Offshore Drilling Rig Control Room

14' x 23' Kit Form Fiberglass Control Room
with Extended Eave Shed Roof, Complete Electrical Services & HVAC Unit

This fiberglass control room was manufactured as a kit for assembly on an offshore oil platform, due to the lack of overhead crane access where it was installed.  As shown here in it's assembled form, the building consisted of four exterior walls, an inner partition and a three piece roof, all joined with stainless steel trim inside and out.  Each section shipped complete with electrical devices intact, with exception to the HVAC unit and light fixtures, which were shipped loose.  Each piece was then hand-ported into position by a determined group of oil-field workers, who used dollies to move the pieces approximately 100 feet from the rig deck and small jib cranes to place the roof.